I came back from the Thanksgiving Holiday all pumped up to work on the Cub. With the floorboards in, it's going to go quickly again for a while. I managed to find the screws and the screwholes for the trim, throttle plates, carb heat and fuel shut-off valves to fasten all of those down. I put the front seat in just to see how it fit and so I could start dreaming of making airplane noises. After I took it out, I put in the control sticks. They still have masking paper on the grips. The two rudder pedals have the springs on them but since that's where the seat goes, they are not tightened down yet. 
No comments:
Post a Comment